Desktop Tensile Tester, Desktop Tensile Tester Manufacturer

Desktop Tensile Tester, Desktop Tensile Tester Manufacturer

Haida Instrument 400-071-1808/0769-89280808

Table type tensile tester can mainly measure the tensile force, tearing, peeling, adhesive force ... resistance of various materials.

Design standards: ASTM D903 , GB/T16491 , GB/T1040 , GB/T8808 , GB13022 , GB/T 2790/2791/2792 , CNS-11888 , JIS K6854, PSTC-7

Table type tensile tester main technical parameters:

Capacity: 2kg , 50Kg ( optional pull force meter )

Unit switching: Kg , N

Load resolution: 1/10,000

Load accuracy: ± 1%

Maximum stroke: 650mm ( without clamps )

Test speed: 20 to 300mm/min ( knob adjustment )

Dimensions: (L × W × H) 270 × 430 × 1140mm

Weight: 36Kg

Power supply: 1 ∮, 220V/50Hz

Power System: Speed ​​Motor

Transmission mode: ball screw

Distribution: a set of tension clamp

Desktop Tensile Tester Maintenance and Care Steps

1. Before testing, the tensile testing machine must ensure that the system is warmed up more than 20 minutes in advance so as to minimize the influence of temperature.
2. The buffer oil should be kept clean. When the oil level is less than two-thirds of the depth of the barrel , it should be replaced immediately.
3 , before the start of the tensile tester, check whether the rubbing active parts should be filled with lubricating oil.
4. Before holding the test piece, the brake handle must be stuck, and then add the test piece and release it.
5 , dynamometer main bearings do not allow refueling. The surface of the friction wheel in the gearbox must not be oiled or splashed with oil. The friction surface must be clean and clean, and the bevel block on the swing arm must not be violently impacted.
6, the test is completed, after the power is turned off to give test machine for cleaning the surface, timely protection to prevent surface rusting.
7. On average, maintain the pulling machine 2 or 3 times a month.